Aero-motive RB2 Series Service Manual

IMPORTANT SAFETY INFORMATION
Please read this manual carefully and follow its instructions. Improper use or failure to follow these instructions could
result in serious injury, property damage or death
and maintenance of this product. Keep this manual for future reference.
The following signal words and meanings are intended to explain the levels of risk associated with this product.
DANGER: Indicates a hazardous situation that, if not avoided, WILL result in serious injury or death
WARNING: Indicates a hazardous situation that, if not avoided, COULD result in serious injury or death
CAUTION: Indicates a hazardous situation that, if not avoided, MAY result in minor or moderate injury
INSTALLATION
MOUNTING
READ INSTRUCTIONS BEFORE USE To avoid injury: all operators should be instructed in
CAUTION:
the safe, proper use and maintenance of this product.
WARNING: Main support device must have break strength exceeding 6 times weight of load.
CAUTION: Use new cotter pin when re-assembling clevis pin.
CAUTION: Do not adjust mainspring tension until tool and attachments are suspended from retractor.
Mounting retractor in wrong configuration, with cable pulling against guide, can cause
CAUTION:
premature cable wear and cable to jam inside retractor.
 Attach retractor to main support
located above work area with
upper mount (swivel fork) and
clevis pin. - See FIG.01
 Secure clevis pin with washer and
cotter pin. - See FIG.01 for upper
mount reference dimensions.
 NOTE: Support must allow swivel
fork to pivot 30° from vertical axis,
perpendicular to clevis pin axis.
Retractor must not be pulled
sideways more than 30° or exceed
free play between support and
swivel fork – See FIG. 02
SM1110-06
Operators must be trained and instructed in the safe and proper use
.
FIG. 01
Page 1 of 4
RB2 & RB4 Series Retractors
Service Manual
FIG. 02
REV - C