Advertisement
UNIT POWER SPRING TENSION ADJUSTMENT
READ INSTRUCTIONS BEFORE USE To avoid injury: all operators should be instructed in
CAUTION:
the safe, proper use and maintenance of this product.
CABLE CAN RETURN SUDDENLY
WARNING:
attached to retractor before adjusting tension.
CAUTION:
Do NOT Over-Tension balancer main spring. This will reduce cable travel and spring life.
Before making spring tension adjustments please check the following:
Tool and all accessories are attached to lower tool clip.
If tool attached to retractor cable descends, there is not enough tension on retractor mainspring.
If cable stop is tight up against cable guide, there is too much tension on retractor main spring.
Unit Tension Adjustment
To increase tension, turn Tension Knob (on the front of the retractor) clockwise or in the "+" direction until
desired tension is achieved – See FIG. 06.
Make sure Tension Knob has engaged back the ratchet teeth on front case before releasing Tension Knob.
To decrease tension, pull Tension Knob out such as to disengage from ratchet teeth on front of case and
turn counter-clockwise or in the "-" direction until pre-load is relieved from cable stop – See FIG. 06.
Make sure Tension Knob has engaged back the ratchet teeth on front case before releasing Tension Knob.
SM1110-06
To avoid serious injury or death: Load MUST be fully
FIG. 06
Page 3 of 4
REV - C
Advertisement
