Page 1
FILE NO. : DSE-NH-4-5SC1400P10-V20A EDITION : V20A DATE : 2020/11/24 Prepared By Checked By Approved By MOTOMA POWER CO.,LTD Http: // www.motoma.com E-mail:info@motoma.com Manufacturer reserves the right to alter or amend the design, model and specification without prior notice. 1. SCOPE...
Http: // www.motoma.com E-mail: info@motoma.com This specification applies to MOTOMA sealed nickel metal-hydride cylindrical rechargeable single battery and stack-up battery packs. All the data involving voltage and weight of stack-up battery packs equal to the value of single cell times the number of single cell in the battery packs.
Page 3
MOTOMA POWER CO., LTD Http: // www.motoma.com E-mail: info@motoma.com 5.1 Testing conditions The battery shall be evaluated within 1 month from the arrival date. Unless otherwise stated in these specifications, the battery to be tested shall be stored for not more than 1 hour at an ambient temperature of 20±5℃...
Page 4
MOTOMA POWER CO., LTD Http: // www.motoma.com E-mail: info@motoma.com Prior to the endurance in cycles test, the battery shall be discharged at 140mA to 1.0V. The battery shall be capable of 500 minimum cycles under the conditions as follows. TABLE 3: Cycle Life Test...
Page 5
8. WARNING ! Do not apply water, seawater or other oxidizing reagents to MOTOMA batteries, as this can caused rust and heat generation. If a battery becomes rusted, the gas release vent may no longer operate, and can result in explosion.
Page 6
This may cause leakage of battery fluid and heat generation. If the MOTOMA battery terminals become dirty, clean up them with a soft dry cloth prior to use. Dirt on the terminals can result in poor contact with the equipment, loss of power, or inability to charge.
Need help?
Do you have a question about the NH-4-5SC1400P and is the answer not in the manual?
Questions and answers