Use Of The Same Dsp Line By Multiple Parts; Channel Aftertouch; Pitch Bend - Casio AP-200 Manual

11.2.3

Use of the Same DSP Line by Multiple Parts

When multiple parts that select tones that use DSP and all of the following settings are the same, the same DSP line is
assigned to all of the parts in order to maximize DSP line availability.
Tone Number
•
Part Volume
•
Part Pan
•
All DSP parameters
•
After the same DSP line is assigned to different parts as described here, Part Volume, Pan, Reverb Send, Chorus Send,
Acoustic Resonance Send, and all DSP parameter settings are common to all parts. Note that changing the settings on any
part will also affect all of the other parts that are sharing the DSP line. To assign the parts to a different DSP line, you
need to change one of the parameters listed above before selecting the tone.
12

Channel Aftertouch

Format
Message Format: DnH vvH
n: MIDI Channel Number
vv: Value
Send
These messages are never sent.
Receive
Receipt of this message adds modulation to the voice that is sounding. The modulation effect differs according to the tone
being used.
13

Pitch Bend

Format
Message Format: EnH llH mmH
n: MIDI Channel Number
ll: Value LSB
mm: Value MSB
Send
These messages are never sent.
Receive
Receipt changes the pitch of the currently sounding note. The change depends on the pitch bend sensitivity configured
with RPN.
20