Storing Outboard Motor; Procedure - Yamaha F80A Owner's Manual

ered in the normal running position, use
an additional support device to secure it
in the tilt position.
The outboard motor should be trailered and
stored in the normal running position. If there
is insufficient road clearance in this position,
then trailer the outboard motor in the tilt po-
sition using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
EMU28241

Storing outboard motor

When storing your Yamaha outboard motor
for prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage.
It is advisable to have your outboard motor
serviced by an authorized Yamaha dealer
prior to storage. However, you, the owner,
with a minimum of tools, can perform the fol-
lowing procedures.
ECM01080
CAUTION:
To prevent problems which can be
G
caused by oil entering the cylinder from
the sump, keep the outboard motor in
the attitude shown when transporting
and storing it. If storing or transporting
the outboard motor on its side (not up-
right), put it on a cushion after draining
the engine oil.
Do not place the outboard motor on its
G
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through
the exhaust port and cause engine trou-
ble.
Store the outboard motor in a dry, well-
G
ventilated place, not in direct sunlight.
EMU28301

Procedure

EMU28321
Flushing with the flushing attachment
Flushing with the flushing attachment
1. Wash the outboard motor body using
fresh water. For further information, see
page 45.
2. Disconnect the fuel line from the motor
or shut off the fuel cock, if equipped.
3. Remove the engine top cowling and si-
lencer cover. Remove the propeller.
4. Install the flushing attachment over the
cooling water inlet.
ECM00300
CAUTION:
Do not run the engine without supplying
it with cooling water. Either the engine
water pump will be damaged or the en-
gine will be damaged from overheating.
Before starting the engine, be sure to
supply water to the cooling water passag-
es.
ECM00310
CAUTION:
Avoid running the outboard motor at high
speed while on the flushing attachment,
otherwise overheating could occur.
Maintenance
ZMU04261
42