Cavalier niagara Traditional Instructions

IMPORTANT
Please read these instructions carefully and keep in a safe place for future reference. If you are unsure of any part
of the instructions in this document then we recommend that you contact a reputable qualified trades person.
INTRODUCTION
The Model supplied may vary from the image shown below. Please note that the general installation process for all
standard Shower Sets are the same and the following guide will take you through the process.
1) Upper pole
2) Top head
3) Connector
4) Handset holder
5) Lower pole
6) 'O' ring
7) Divertor
8) Valve
9/10/11) Valve fixing plate
& fixing screws
12) Nut
13) Plate
14) Hose
15) Hand shower
16) Cover plate
17/18/19) Fixing Kits
BEFORE INSTALLATION
1) Warning: Before installing the new shower valve it is essential that you thoroughly flush through the pipework
in order to remove any remaining swarf, solder, etc. Failure to carry out this procedure could cause problems or
damage to the workings of the shower valve.
3) Before installation identify all components and inspect the product for any damage. A claim will not be
accepted if an obvious defect is found after installation.
Traditional Shower Set
[ 1 ]
[ 2 ]
[ 15 ]
[ 14 ]
[ 6 ]
[ 7 ]
[ 6 ]
[ 8 ]
www.cavalierbathrooms.co.uk
Instruction
[ 18 ]
[17 ]
[ 19 ]
[ 16 ]
[ 3 ]
[ 4 ]
[ 5 ]
[ 9 ]
[10 ]
[ 11]
[ 13 ]
[ 12 ]
C20 V2