Dover Nertune E Series Quick Start Manual

ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR NEPTUNE MIXER,

Description

Series E & H Mixers are designed for economical mixing of
closed head steel drums. The mixer mounts by screwing
into the 2" bung opening. The folding propeller collapses to
allow entry through the 2" bung and opens when operating
to provide thorough mixing. The unit can be conveniently
moved from one container to another.
MODEL SERIES"H"

Unpacking

When unpacking the mixer, check carefully for
damage that may have occurred during transit. Check
for missing parts.
www.neptune1.com
A COMPANY
SERIES E & H DRUM MIXERS
READ THESE INSTRUCTIONS BEFORE USING.
MODEL SERIES"E"
295 DeKalb Pike
North Wales, PA 19454
NEPTUNE
MEMBER OF
Tel: 215-699-8700
TM Fax: 215-699-0370
Toll Free Fax: 1-800-255-4017
PUMP SOLUTIONS GROUP
A DOVER COMPANY

General Safety Information

Warning: These mixers are intended for specific
functions. Please follow all instructions to
insure safe and proper use.
(1) Be certain that all mounting hardware and the coupling
and propeller set screws are properly tightened prior to
operation.
(2) Screw adapter into 2" bung opening in drum head. Be
certain propeller is not touching side or bottom of drum.
(3) Series E & H Mixers are intended for use on steel drums.
(4) Perform electrical connections and wiring in accordance
with the electrical area requirements and local electrical
codes.
(5) Do not attempt to adjust mixer when mixer is operating,
this could result in personal injury or damage to the tank
and mixer.
(6) Always wear required safety equipment including eye
protection when observing mixer performance or when
adding materials to a tank while the mixer is operating.

Assembly Instructions

Models E & H Mixers
(1) Bolt motor to bung adapter using enclosed hardware.
(2) Attach coupling to motor shaft using setscrews. Note, the
end of the coupling with the two setscrews spaced closely
together attach to the motor.
(3) Attach propeller to round end of mixer shaft.
(4) Insert end of shaft with flat into coupling and tighten
setscrews.
(5) Recheck all hardware for proper tightening.
(6) Attach to tank by threading into 2" bung opening.
ZL106476