Amber 4244 Installation Manual

4 channel fork lift truck mounting

MODEL 4244

4 CHANNEL FORK LIFT TRUCK MOUNTING

TRANSMITTER INSTALLATION MANUAL

NOTE: The model 4244 Transmitter operates in conjunction with the

Amber model 4224 4 Channel Receiver.

SPECIFICATION

Operating temperature range: -20 to +60 degrees Celsius.

Enclosure & Buttons: IP65

Operating frequency: 433.92 MHz.

Transmitter code type: Rolling code.

Battery: CR2450 Lithium 3V. The battery life should be in excess of 10 years.

ANTENNA

Note that the antenna is internal.

The Transmitter case may be mounted either on the facia of the fork lift truck

or on the engine cover to the right-hand side of the driver's seat using the

4 TEK screws provided

LED Note that the red LED will illuminate when a button is pressed, to confirm

that the transmitter is working.

The brightness of the LED is an indication of the state of charge of the battery.

Page 1

Amber Controls. 3 Gisborne Close, Yoxall, Staffordshire, DE13 8NU England.

Tel: ++44-1543-372094

sales@amber-controls.com

Table of Contents

Do you have a question about the 4244 and is the answer not in the manual?

Page 1 MODEL 4244 4 CHANNEL FORK LIFT TRUCK MOUNTING TRANSMITTER INSTALLATION MANUAL NOTE: The model 4244 Transmitter operates in conjunction with the Amber model 4224 4 Channel Receiver. SPECIFICATION Operating temperature range: -20 to +60 degrees Celsius. Enclosure & Buttons: IP65 Operating frequency: 433.92 MHz.
Page 2 5th door is likely to be out of operating range of the first door. RECEIVER WIRING Please refer to the instructions for the Amber model 4224 Remote Control Receiver. Although it is possible to connect each group of 4 doors to one receiver. It is preferable to install a separate receiver for each door as the receiver’s position...
Page 3 3. Release the LEARN button when the LED turns off. 4. The RED LED LD1 will illuminate for 2 seconds to confirm that all codes have been erased. Page 3 Amber Controls. 3 Gisborne Close, Yoxall, Staffordshire, DE13 8NU England. Tel: ++44-1543-372094 sales@amber-controls.com...
Page 4 3. Then press button 1 of the new transmitter TWICE. 4. Test the operation of the new transmitter to confirm that the new code has been stored in memory. Page 4 REV04 4-04-2022 Amber Controls. 3 Gisborne Close, Yoxall, Staffordshire, DE13 8NU England. Tel: ++44-1543-372094 sales@amber-controls.com...