Related Manuals for DigiTech AA2170
Summary of Contents for DigiTech AA2170
- Page 1 Active Noise Cancelling Headphones with Bluetooth® 5.1 Model: AA2170 Instruction Manual...
- Page 2 BUTTON OPERATING INSTRUCTIONS: Push upward to turn on noise reduction. Led light: Green light. ANC On. Push down to turn off the noise reduction. ANC Off. [ - ] In Wireless mode: Short Press: Volume down. Long Press: Previous song. [ + ] In Wireless mode: Short Press: Volume up.
- Page 3 The Red/Blue light will start to blink. On your Smart Phone/Bluetooth® Device, turn on Bluetooth and search for device name “AA2170”. Pair your Smart Phone/Bluetooth® Device to “AA2170”, it should connect automatically. Note: On occasion it may request for a password before pairing.
- Page 4 SPECIFICATIONS: Φ40mm Speaker: Wireless Distance Range: Bluetooth Version: Battery Capacity: 400mAh Noise Canceling On Only: 12-15 hours Bluetooth On Only: 12-15 hours Bluetooth + Noise Canceling: 6-12 hours Charging Time: 1.5 hours Microphone: 2pcs (-42db±2db) Noise-Cancellation: 20~22db Frequency response: 20Hz-20KHz Charging Input: 5V /1A, Micro USB Distributed by:...
Need help?
Do you have a question about the AA2170 and is the answer not in the manual?
Questions and answers
headphones keep turning off when pairing
The DigiTech AA2170 headphones may keep turning off when pairing if the power button is not held long enough, the battery is low, or the pairing process is not completed successfully. Ensure the headphones are fully charged, press and hold the power button until the Red/Blue light blinks, and complete the pairing using the correct device name “AA2170” and password “0000” if prompted.
This answer is automatically generated
why wont my hheadphones pair with my phone
Your DigiTech AA2170 headphones may not pair with your phone due to the following reasons:
1. Bluetooth Not Enabled – Ensure Bluetooth is turned on in your phone's settings.
2. Headphones Not in Pairing Mode – Press and hold the power button until the Red/Blue light blinks, indicating pairing mode.
3. Incorrect Device Selection – Make sure you select "AA2170" from the list of available Bluetooth devices.
4. Password Required – If prompted for a password, enter "0000".
5. Already Connected to Another Device – Disconnect the headphones from other devices before pairing again.
6. Low Battery – Charge the headphones before attempting to pair.
Try these steps and restart both devices if needed.
This answer is automatically generated