Vechline SoPure Owner's Manual
  1. Manuals
  2. Brands
  3. Vechline Manuals
  4. Inverter
  5. SoPure
  6. Owner's manual

Vechline SoPure Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Special Feature:
Fuse:Built-out
Remote control(Optional)
Power ON-OFF switch
USB:5V, 2.1A(Optional)
Two multiple controlled DC fans: Temperature and load.
Protection: LED Indicator&Audible Alarm.
Output wave form: Pure Sine Wave
CE and RoHS Approved
Congratulations and thank you for purchasing our pure sine wave inverter. Carefully
read,understand and comply with all instructions before use.
OWNER'S MANUAL
Pure Sine Wave Inverter
DC-AC Power Inverter
1

Advertisement

Table of Contents
loading

Related Manuals for Vechline SoPure

Summary of Contents for Vechline SoPure

  • Page 1 OWNER’S MANUAL Pure Sine Wave Inverter DC-AC Power Inverter Special Feature:  Fuse:Built-out  Remote control(Optional)  Power ON-OFF switch  USB:5V, 2.1A(Optional)  Two multiple controlled DC fans: Temperature and load.  Protection: LED Indicator&Audible Alarm.  Output wave form: Pure Sine Wave ...

  • Page 2: Table Of Contents

    Table of contents I-INTRODUCTION ..........................3 1.1 What is an Inverter? ........................ 3 1.2 Pure Sine Wave Inverter ......................3 2. MAIN COMPONENTS ........................3 2.1 Front Panel ..........................3 2.2 Rear Panel ..........................4 3. HOW TO USE INVERTER ........................ 5 3.1 Load consideration ........................

  • Page 3: I-Introduction

    I-INTRODUCTION 1.1 What is an Inverter? Power inverter is an electronic device that convert DC (Direct Current) battery power to standard AC (Alternating Current) power. DC is the power that is produced by battery while AC is the standard power needed to run electrical equipment. A power inverter does the opposite of a rectifier and is used in places and situations where AC power is not available.

  • Page 4: Rear Panel

    C.AC Output Receptacle: For application demands of different geographic areas all over the world, there are many different kinds of optional AC receptacle to choose from. D.Vent outlet To decrease the temperature of the inverter F.Remote switch port(Optional): Use to connect the remote ON/OFF switch via a communication cable. Refer to Appendix G.Hardwire Terminal Block(3000w): Note: When the load current is>15A,must use output terminal connection which can be found inside the AC output panel of the inverter.

  • Page 5: How To Use Inverter

    3. HOW TO USE INVERTER 3.1 Load consideration When an appliance with motor starts, it requires a momentary surge of power. This surge of power is the “start load” or “peak load”. Once started, the appliance require less power to continue to operate.

  • Page 6: Mounting Position Of The Inverter

    compartment as batteries. 3.5 Mounting position of the inverter The inverter may be mounted horizontally on the top of a horizontal surface or under a horizontal surface. The inverter may be mounted on a vertica1 surface only horizontally 3.6 Getting Connected Follow the connection sequence described below.

  • Page 7: Protection Feature

    disassemble or service the unit can result in electrical hazard, including death from exposure to high voltage. If you experience problems with the unit, discontinue use and Contact Technician. 11.When cleaning the inverter, please switch off power(unplug the inverter).Carefully clean with dry cloth.

  • Page 8: 6．Troubleshooting Reference

    AC output will automatically shut off. 6．TROUBLESHOOTING REFERENCE Acoustics buzzer alarms When applying the inverter to acoustics device, some inferior acoustics device will buzz, this is because the output wave from the inverter is modified sine wave inverter. Note: * When 190%≤Load≤200%,limit current of AC output, that’s to say AC Output Voltage decreasing, output shut down, delay 60s to restart automatically, once ten consecutive restart automatically, then you have to start the inverter by manual.

  • Page 9: Mechanical Drawing

    Power tools–circular saws, drills, grinders, sanders, buffers, weed and hedge trimmers, air compressors. Office equipment – computers, printers, monitors, facsimile machines, scanners. Home entertainment electronics – television, VCRs, video games, stereos, musical instruments, satellite equipment. 10. MECHANICAL DRAWING Front and back Panels 1000W 2000W 3000W...

  • Page 10: Installation

    D) Hardwire Terminal Block: When the load current is >15A, must use output terminal connection. AC Input Terminal Block: a screw type terminal block for attaching AC output wires. Each slot is labeled L for Lines and N for Neutral. Connect the incoming Line wire to the input L slot, Connect the incoming Neutral wire to the input N slot.

  • Page 11: Remote Control Switch

    12.REMOTE CONTROL SWITCH 500W 466382B/466385B/466386B 2000W/3000W...

  • Page 12: Warrantly

    Power ON/OFF Switch A. Power ON/OFF switch is to turn the inverter on or off. Battery Capacity/Load Voltage indicator B. Load: Show the approximate connected equipment load level. 5 Levels---20%,40%,60%,80%,100%. C. Battery: Show the battery residual capacity. 5 Levels---20%,40%,60%,80%,100%. AC In Indicator D.

Table of Contents