PROFECO 77405 Instruction Manual page 21

 Switch on the engine according to the instructions and with
your feet well away from rotating parts.
 Do not tilt the unit when switching on the engine, except if the
unit must be tilted for starting. In this case, do not tilt the unit
more than is absolutely necessary and only lift the part which
is away from the operator. Always ensure that both hands are
in the operating position before placing the unit back on the
ground. Do not place hands or feet near or under rotating
parts.
 Never pick up or carry a device while the engine is running.
Pull the plug out of the socket:
 Every time you leave the machine.
 Before clearing a blockage.
 After hitting a foreign object. Check the unit for damage and
carry out repairs if necessary.
 If the unit starts to vibrate abnormally, check it immediately.
When the machine is working in dense brush or encounters
obstacles that it cannot cut, the blade will come to a stop, increasing
the machine temperature and flow. When the temperature rises too
high or the current is too great, the overload protection device
installed in the machine will automatically switch off the current to
stop the machine (main purpose is to protect the motor and extend
its service life). At this time, release the trigger and disconnect the
machine from the power supply, let the machine cool down for some
time (1~2 min) and then restart the switch, the machine can work
again.
Symbols
Symbols may be found on the rating plate of your tool. These
stand for important information about the product or
instructions for its use.
Waste electrical products must not be disposed of with household
waste. Please recycle where facilities exist. Contact your local
authority or dealer for advice on recycling.
21