Using The Remote; Modes Of Operation; Manual Reset - RCA L42FHD2X48 User Manual

6. When all codes have been searched, the CANCEL button blinks rapidly to indicate failure, and the remote
returns to normal operation.
Note: If you accidentally passed the code before saving it, use the left arrow to backtrack through the codes. Use
the right arrow to go forward through the codes again. Once the left or right arrow has been pressed, the search
mode changes to Manual Code Search.

Using the Remote

Once the remote has been programmed successfully, it is ready to operate your components.
To operate the component:
1. Press the component button (SAT/AUX or DVD) to set the remote to control the component. For
example, press DVD to control your DVD player.
2. Press ON•OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.

Modes of Operation

The button that corresponds to the mode the remote is in illuminates when you press any button that
applies to the component. For example, if you're in TV Mode and you press the VOL+ button, the TV button
lights up. This tells you that the command to increase the volume is being sent to the TV.
Note: The remote control may not be compatible with all brands and models of components.

Manual Reset

The Manual Reset is used to reset the remote settings to default.
Note: The reset can also be accomplished by replacing the batteries; however replacing the batteries does not
always cause a reset. You can perform a manual reset by following these steps:
1. On your remote control, simultaneously press the V-Chip, ON•OFF and MUTE buttons.
2. The CANCEL button will blink slowly to indicate success, and the remote control returns to normal
operation.
Using the Remote Control
23
Chapter 2