Component Connection Methods - RCA DVR10 User Manual

Overview & Setup
The 1394 interface reduces the number of cables needed to connect each device and simplifies
the connection process. There is no need to ensure that you are connecting the correct audio
or video cable to the correct jack. IEEE 1394 uses a single cable to transfer audio, video, and
interface data between all devices connected within the chain.
The DVR10 has two 1394 ports. This allows you to use one port for connection to your digital
television and still have another port for connection of additional 1394 components. Each
compatible device connected on the IEEE 1394 chain is shown on the DTV. Information can be
sent between 1394 connected components. DTVLink and other compatible components can be
controlled from your DTV.

Component Connection Methods

There are two ways to connect IEEE 1394 and DTVLink devices: component-to-component and
hub connection. The component-to-component method has each component connected in a
chain-like fashion, with the DTV as the first component. The hub method is basically the same but
uses both 1394 jacks on the DTV with two chains of components connected to it.
Note: Use a single 1394 cable to connect one device to any available 1394 port on the next device. If devices such as a
digital camera only have one 1394 port, these devices should be placed at the end of the 1394 chain.
6
Illustrations contained in this document are for representation only.
Chapter 1