Mitre 10 BD60D2P-IMP Assembly Instructions

BASE CABINET
3 DRAWER UNIT
Assembly Instructions
Suitable for Base Cabinet
BD60D2P-IMP, BD80D2P-IMP,
BD90D2P-IMP
732.25.817
Note: Connector screws are
used to connect two carcase
units together. 5mm through
holes are provided on some
of the front edges of the side
panels to connect adjacent
carcase.
Handy Note:
Please read the instructions carefully before you start and make sure to identify the parts you need for each step.
When assembling it is best to do on a soft surface to prevent damage.
Cabinet
Panels
included.
Bottom Panel x1 Back Panel x1
SCREWS
Hardware
included.
Legend
A. = BD60D2P-IMP
B. = BD80D2P-IMP
BD90D2P-IMP
POWER DRILL
Required
Tools.
CLAMP
Handy
Tools.
Manufactured in New Zealand for: Mitre 10 New Zealand Limited.
Side Panels x2 Rail Panel x1 Drawer Base Panel x3
CONNECTOR LEG BASES KICK CLIP ( 2 )
( 4 )
SCREWS ( 2 )
ADJ. LEGS ( 4 )
DOWELS ( 16 ) TOP FIXING
BRACKET ( 2 )
FOOT
( 4 )
PZ2 BIT
5MM RUBBER
DRILL BIT MALLET
LEVEL TAPE PENCIL
MEASURE
1.
Installing Leg Bases.
• Fix the Leg bases by aligning them on the base panel as shown.
• Ensure dowels in the leg bases line up with the holes. Use a block of wood
between leg base and mallet to prevent damage before striking it into place.
2.
Fixing Bottom and Back Panel.
• Lay the back down flat as shown.
• Use 50mm Cabinet Screws to fix the bottom panel to the back panel.
DRAWER BACKS ( 3 )
GALLERY RAIL SETS
( 2 )
DRAWER
SETS
( 3 )
3.
Inserting Dowels
into Side Panels
SCREWDRIVER
• While laying the panels flat, insert
the dowels into the correct holes as
marked in the image shown.
LADDER
Note: Position leg base as shown
in the image to support side panel.