KNOVA KN SR-01 Quick Start Manual page 3

ASSEMBLY INSTRUCTIONS
Connect the leg assembly (3) and stand assembly (4) with the
hex bolt as shown in Fig 2.
Use the hex key to tighten the hex bolt, make sure the leg
assembly is locked firmly as shown in Fig 3. Repeat this step
with the other leg assembly (3).
Step 3.
Put the roller assembly (1) on the stand assembly and connect
them with two hex bolts and washers (5). Use the hex key to
tighten the hex bolts as show in Fig 4.
Fig. 2
Step 4.
NOTE: You can adjust the height of the stand with the
NOTE: Set the roller assembly parallel with the leg assembly
Fig. 5
Fig. 3
Fig. 4
adjustment handle by turning counter-clockwise to
loosen. While loose, raise the roller assembly to
desired height and turn adjustment handle clockwise to
tighten in place as shown in Fig 5.
to support a longer work-piece more firmly.
Fig. 6