Specifications; Technical Data; Important Safety Information; Parts Description - KNOVA KN SR-01 Quick Start Manual

SPECIFICATIONS

TECHNICAL DATA

Model
Open size:
Out tube:
Adjustable tube:
Roller width:
Rotary drum dia:
Base tube dia:
Weight capacity:
Weight:

IMPORTANT SAFETY INFORMATION

WARNING
READ, UNDERSTAND AND FOLLOW
ALL INSTRUCTIONS AND WARNINGS BEFORE
OPERATING THIS TOOL. FAILURE TO DO SO MAY
RESULT IN PERSONAL INJURY AND/OR
PROPERTY DAMAGE AND WILL VOID WARRANTY.
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Ensure roller support stand
is set up on firm, level ground in a stable manner.
3. Keep children away. Children must never be allowed in
the work area. Do not let them handle machines, tools,
or extension cords.
4. Be aware of over-balancing. When a large piece is cut from
one end of a job, the remaining piece may be heavy
enough to tip the stander. Always ensure the workpiece
is well supported.
5. Use the right tool for the job. Do not modify this tool and
do not use this tool for a purpose for which it was not
intended.
6. Dress properly. Do not wear loose clothing or jewelry as
they can be caught in moving parts. Protective, electrically
non-conductive clothes and non-skid footwear are
recommended when working. Wear restrictive hair
covering to contain long hair.
7. Use eye and ear protection. Always wear ANSI approved
impact safety goggles.
8. Work Safe. Keep proper footing and balance at all times.
Never use support stand as step ladder, nor stand on
support stand top. Never exceed recommended maximum
weight capacity of support stand (132 lbs.). Always lower
heavy loads onto stand gently, so that strain is taken up
gradually.
9. Stay alert. Watch what you are doing, use common sense.
Do not operate any tool when you are tired.
10. Check to make sure that all fixing screws and knobs are
tight and all legs are locked into place before operating
the stand.
11. Check damaged parts. Before further use of tool, it should
be carefully checked to determine that it will operate
properly and perform its intended function.
12. Do not operate any tool if under the influence of alcohol
or drugs. Read warning labels on prescriptions to
determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate any tool.
13. When not in use, tools should be stored in a dry locked-up
place, out of the reach of children and persons unfamiliar
with the tool.
KN SR-01
17.3 x 19.6 x 26.3 in - 43.3 in
1.18 x 1.18 x 0.04 in
0.98 x 0.98 x 0.04 in
11 in
1.88 in
0.98 in
132 lbs
8.4 lbs
WARNING
The use of any accessory or attachment
other than one recommended in this instruction
manual may present a risk of personal injury.
WARNING
The warnings, cautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions and situations that may occur.
It must be understood by the operator that common
sense and caution are factors which cannot be built
into this product, but must be supplied by the
operator. Read and understand all of the instructions
provided in the instruction manual as well as any other
tool (s) used with the roller support stand.

PARTS DESCRIPTION

2
4
1 Roller Assembly
2 Height Adjustment Handle
3 Leg Assembly
4 Stand Assembly
5 Hex key & Hardware
ASSEMBLY INSTRUCTIONS
Use hex key provided.
Step 1.
Remove the pins from the leg assembly (3) and insert the pins
into the holes of the stand assembly (4) as shown in Fig. 1.
Fig. 1
1
3
5