Yoshitake MS-1 Product Manual

Thank you very much for choosing the Yoshitake's product. To ensure the correct and safe use of the

product, please read this manual before use. This manual shall be kept with care for future references.

The symbols used in this manual have the following meanings.

Warning

Caution

1. Specifications ···························································· 1

2. Dimensions and weight ··············································· 1

3. Nominal size selection method ····································· 2

Warranty Information

MODEL MS-1,2,3,4

Noiseless Heater

PRODUCT MANUAL

This symbol indicates a potentially hazardous situation that, if not avoided,

could result in death or serious injury.

This symbol indicates a hazardous situation that, if not avoided, may result

in minor or moderate injury or may result in only property damage.

4.1 Precautions for installation ····································· 3

4.2 Example of piping ·············································· 3-4

4.3. Precautions for operation ······································ 4

■EPDT-197■

Table of Contents

Need help?

Do you have a question about the MS-1 and is the answer not in the manual?

Page 1 Noiseless Heater PRODUCT MANUAL Thank you very much for choosing the Yoshitake’s product. To ensure the correct and safe use of the product, please read this manual before use. This manual shall be kept with care for future references. The symbols used in this manual have the following meanings.
Page 2 60℃ 90℃ temperature limit Material Bronze Stainless Steel Bronze Stainless Steel Connection JIS Rc screwed 2. Dimensions and weight [MS-1, MS-3-13] (mm) Nominal Weight size (kg) Rc 1/2 Rc 3/4 Rc 1 Rc 1 1/4 Rc 1 1/2 Rc 2...
Page 3 3. Nominal size selection method ●Nominal size selection chart [MS-2, MS-4-13] [MS-1, MS-3-13] ●Formula for calculating the required nominal size The steam volume “W” required to raise the temperature of “Q” amount of water by “B” degrees Celsius in “A” amount of time is calculated as follows: W: Steam volume (kg/h) ×...
Page 4 4. Installation and operation 4.1 Precautions for installation  Caution (1) The noiseless heater should be mounted 300mm or more from the tank’s walls and bottom. (Refer to 4.2 Example of piping) * Vibration may occur in a tank by the flow of a liquid. (2) Use it within the maximum warning sound temperature limit.
Page 5 Fig.3 Fig.5 Fig.4 4.3. Precautions for operation  Warning (1) Do not touch the product by bare hands * Failure to follow this notice may cause burn or injury. (2) Submerge the product (In the case of Fig. 3, the tip of the pipe) in the water (liquid) in the tank.

Ms-2Ms-3Ms-4