Advertisement
INSTALLATION INFORMATION
Accessories
Find the following when unpacking the Registration Interface:
An ImproX (RH) Registration Interface housed in a Black, Aluminium extruded
Cabinet. The Cabinet consists of a Top Cover, a Base and two End Plates (each
End Plate is attached with three Thread Cutter Screws (M3 x 8 mm)).
Four Brass Wood Screws (3.5 mm x 25 mm).
Four Wall Plugs (7 mm).
A 1.8 m (5.90 ft) standard USB Cable with a Type A to Type B Connector.
An extra Fixed Address Label.
General
Remember the following when installing the Registration Interface:
FCC Compliance
For FCC compliance:
Ensure the comms cable is routed through a separate grommet to the power
cable.
Ensure that you use a CE approved Power Supply Unit.
Communications Distance
The USB communications distance between the Host PC and the Registration
Interface MUST NOT exceed 5 m (16.40 ft).
DO NOT cut and join the supplied USB Cable. If extension of the USB Cable is
required, source a new longer length USB Cable.
Distance between the Registration Interface and the ImproX RRM or
ImproX RRA
The maximum cable distance between the ImproX Registration Interface and the
ImproX RRM or ImproX RRA, MUST NOT exceed 2 m (6.56 ft).
Distance between ImproX RRAs or ImproX RRMs from DIFFERENT
Registration Interfaces
To avoid mutual interference install the ImproX RRAs or ImproX RRMs no closer than
500 mm (20 in) apart.
XRH300-0-0-GB-06
June 2007
Page 2
Advertisement
