IMPORTANT SAFETY ADVICE THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your panel heater for the first time and keep them in a safe place.
WARNING - THE SURFACES ON THIS HEATER CAN BE HOT. The heater carries a warning symbol to alert the user to the risk of fire that exists if the heater is accidentally covered. CAUTION - Some parts of this product can become very hot and cause burns.
OPERATING WARNINGS IMPORTANT: Remember to observe all safety warnings and precautions when operating the heater on the automatic or timer modes, either attended or unattended since a fire risk exists when the heater is accidentally covered or displaced. CAUTION: Do not use if the heater’s main power lead is damaged. If the supply cord is damaged it must be replaced by the installer or an approved Nobo service partner.
IMPORTANT SAFETY ADVICE Exposed to the Near water If the power cable weather outdoors wires are frayed or cut Where small children If an extension Where the power may be left lead may become cable may be unattended overloaded damaged On a slope or Where there is risk Where it may be...
Page 6
Sizing Options WATTAGE PRODUCT CODE DIMENSIONS (MM) WEIGHT (KW) NCPT 10 525W x 400H x 115D 4.3kg NCPT 15 625W x 400H x 115D 4.8kg NCPT 20 925W x 400H x 115D 7.5kg NCPT 24 925W x 400H x 115D 7.5kg...
Page 7
Installation Parts WARNING - Minimum clearances and IP zone requirements must be adhered to. Do not locate the heater immediately below a fixed electrical power point. WARNING: This heater must not be connected to the electricity supply via an external switching device (such as a timer) or circuit that is regularly switched on and off by the utility supplier.
Wall Mounted Installation MINIMUM CLEARANCE: WALL BRACKET INSTALLATION STEPS: The wall bracket can be used as a Mark the location for the two bottom measuring device for placing the screws (A-A) and fasten the two screws heater on the wall. in the wall.
Page 9
Place the wall bracket onto the bottom Place the heater on the wall bracket screws (A-A). Then fasten the wall bracket (1), secure the tilt strap (2) and click the with the top screws. heater onto the top catches (3). To secure the heater safely to the wall, Turn on the switch to operate fasten the screw on each of the two...
Portable Installation CAUTION: Castors/portable installation is only suited for well insulated spaces or occasional use. A: Ensure the enclosed screw (M3.5x10) is in place on the power supply as shown. Assemble foot onto the frame hole. Align the product with reference to slots provided on frame.
Setting the Timer SET DAY AND TIME Press + and simultaneously A: Select 12H/24H (press +) B: Confirm (press C: Set the hour (press + or -) D: Confirm (press E: Set the minutes (press + or -) F: Confirm (press G: Set the day (press + or -) d1: Monday d2: Tuesday...
Page 12
ADAPTIVE START Adaptive Start is an intelligent feature that allows the heater to begin heating the room before the start of the heating period to ensure the room is at the required temperature when the period starts. SET TEMPERATURE / OVERRIDE Red = Comfort Adjust Comfort temperature by...
Page 13
Program Daily Settings EXAMPLE PROFILE Press and + simultaneously A: Select from above programmes for day 1 (Monday) (press + or -) d1 =Monday B: Confirm (press C: Now select from above programmes d2 = Tuesday for day 2 (Tuesday) (press + or -) D: Confirm (press Repeat for each day (d1 to d7)
Override and Childlock OVERRIDE Pressing overrides the status from Comfort to Eco or vice versa. The override is terminated automatically upon the next event in the program, or at 03:00. KEY LOCK Press and - simultaneously to lock or unlock. Cleaning &...
Maintenance If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Recycling: Do not dispose of electrical appliances as unsorted municipal waste.