Related Manuals for Qomo QPT100
Summary of Contents for Qomo QPT100
- Page 1 Intelligent Pen Tray User Manual (Standard Version) QPT100 The Best Choice for Your Perfect Presentation! Information in this manual is subject to change without notice.
- Page 2 Use the pen tray where the ambient temperature is between 0℃ and 40℃. Store the pen tray where the temperature is between -20℃ and 80℃. Make sure the pen tray only works in conjunction with QOMO Flow! Works Pro in...
- Page 3 case of mismatching. Don’t disassemble the pen tray for repair by yourself. Please contact the technicians if there’s any damage. Intelligent Pen Tray Installation Installation on whiteboard with QWB800 Series Note: Please install the pen tray on the whiteboard before mounting the whiteboard onto the wall or to a stand.
- Page 4 Step 3: Attach the pen tray to the whiteboard Attach the pen tray to the whiteboard, aligning the oblong hole on the metal connector with bolts on the whiteboard. Then loosely fasten the nuts, as shown in Figure 3. Step 4: Adjust Adjust the pen tray horizontally to the middle of the whiteboard frame.
- Page 5 Step 5: Add accessories Add the accessories (pointer, eraser and four color-coded pens) into their designated places on the pen tray finally, as shown in Figure 5. Installation on whiteboard with QWB300 Series Note: Please install the pen tray on the whiteboard before mounting the whiteboard onto the wall or to a stand.
- Page 6 Step 2: Connect the cable Insert the connecting plug reserved at the back of whiteboard to the signal interface on the pen tray, as shown in Figure 2. Note: Don’t pull the cable violently. Step 3: Attach the pen tray to the whiteboard Attach the pen tray to the whiteboard with the four bolts on the back of the whiteboard passing through the circular holes in the metal connectors, as shown in Figure 3.
- Page 7 Step 4: Adjust Push the pen tray upward to make its rung seamlessly attached to the bottom of the whiteboard frame and then firmly tighten the screws installed loosely in Step 1. Screw the included 4 hexagonal nuts (Accessory as shown in Figure 3) onto the bolts to finally secure the pen tray, as shown in Figure 4.
-
Page 8: Function Description
Function Description The pen tray comes with four pens, one eraser and one pointer which perform the same functions respectively as pen, object eraser and laser pen when they are interacted with Flow! Works Pro. Specific functions as follows: Black and red pens are in the pen tray for the left side Four pens and the green and blue pens are in the pen tray for the right side. - Page 9 Intelligent Pen Tray contains three modes: writing (pen) mode, eraser mode and pointer mode. 1. Writing (Pen) Mode Picking up any one of the four pens from the pen tray will simultaneously invoke the pen tool of Flow! Works Pro and then enters the writing mode. ...
- Page 10 Flow! Works Pro will default to invoke pen function no matter what tools you use. When you put the pen into its designated slot, eraser will take priority over pointer, and so forth. Note: You can enter Flow!Works Pro Server-Pentray-QPT100 to disable corresponding function. Disable...
-
Page 11: Specification
Specification Model QPT100 Operating Voltage 3.3 V Operating Current 20 mA Power Supply Mode Powered by whiteboard Communication Mode Inter-integrated Circuit (IIC) Operating Temperature 0~+40℃ Storage Temperature -20℃~+80℃ Induction Way Infrared +Magnetic Induction Interactive Software Flow! Works Pro Accessories Pen*4, eraser*1, pointer*1...