Advertisement
Quick Links
- AS4060, AS4190 KIT ACQUA STOP - EN
This document relates to the Smeg "aqua stop device" accessory.
The accessory may only be installed on Smeg appliances. It is a device which enables the appliance to detect
any water leaks and manage them safely, signalling the malfunction and operating the discharge pump to
limit any possible damage.
For proper, safe use, this manual must be used together with the manual of the instrument or glassware
washer on which the accessory is installed.
Failure to read, any misunderstanding or incorrect interpretation of the instructions provided in this manual
may lead to misuse of the appliance, put the operator at risk and considerably reduce the appliance's
performance.
The manufacturer declines all liability for uses other than those described in this manual.
Installation, maintenance and repairs must be carried out only by SMEG authorised staff.
In the event that the device is used in breach of the instructions provided by SMEG, the
manufacturer, the relative warranty rights could be forfeited.
The information in this manual is provided for guidance only. The contents and the equipment described may be
subject to change without notice.
INFORMATION AND AFTER-SALES SERVICE FOR
Our Sales Department staff are able to provide you with information about prices and special offers.
Our After-Sales Department will be able to provide you with guidance about keeping your appliance functioning
correctly and put you in touch with your nearest authorised Service Centre.
902897-903079
AS4060 - AS4190
INSTALLATION INSTRUCTIONS
AQUA STOP DEVICE KIT
READ CAREFULLY
19 560 0117 00
Ed.
SMEG INSTRUMENTS DIVISION PRODUCTS
instruments@smeg.it – service.instruments@smeg.it
Our entire product offering can be viewed at:
www.smeg-instruments.com
International customers, please contact your local SMEG distributor.
30/10/2013
Date
1
Advertisement
Related Manuals for Smeg AS4060
Summary of Contents for Smeg AS4060
- Page 1 This document relates to the Smeg “aqua stop device” accessory. The accessory may only be installed on Smeg appliances. It is a device which enables the appliance to detect any water leaks and manage them safely, signalling the malfunction and operating the discharge pump to limit any possible damage.
- Page 2 N.B.: The blow-up diagram below does not show the metal fasteners (screws, washers, etc.). ACQUASTOP AS4060 902897 – AS4190 903079 The AS4060 accessory can be installed on the following series of Smeg washing appliances. AS4060 Series which can be equipped with...
- Page 3 - AS4060, AS4190 KIT ACQUA STOP - EN PRECAUTIONS A_ Perform an appliance reset cycle. B_ Disconnect the appliance from the electricity supply C_ Remove the detergent intake nozzles from the cans, and remove the cans from the appliance in the case of 4190 appliances.
- Page 4 - AS4060, AS4190 KIT ACQUA STOP - EN PROCEDURE ILLUSTRATION 3. Connect the wiring, taking care since it is not polarised. Figure 3 4. Insert the base tray. Figure 4 5. Fix it with the four screws provided, two in the front and two in the rear.
- Page 5 (max. permitted slant angle: 0.5°). Note Once the kit has been fitted, enable the device using the Smeg “TRACELOG” software programme. Smeg S.p.A. Instruments Division Via Leonardo da Vinci, 4 – 42016 Guastalla (RE) Italy Tel.