Additional information
Resetting the main unit
Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the TONE button,
press and hold the STANDBY/ON button
for about three seconds.
3
When you see RESET? appear in the
display, press ENTER.
OK? shows in the display.
4
Press SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory settings.
Switching the speaker
impedance
We recommend using speakers of 8 Ω with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6 Ω impedance rating.
With the receiver in standby, press
•
STANDBY/ON while holding down the
SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6 Ω.
• SP 8 OHM – Use this setting if your
speakers are rated at 8 Ω or more.
12
65
En