4. Troubleshooting
4-2-3. No Video (Tuner_CVBS)
Note
Refer to the next page to check the location such a CN201 or IC201 SVC Manual mentioned.
Symptom
•
Audio is normal but no picture is displayed on the screen.
•
Check the Tuner CVBS source.
Major
•
Check the Tuner.
checkpoints
•
This may happen when the LVDS cable connecting the Main Board and the Panel is
disconnected.
1
Diagnostics
2
2
Caution
Make sure to disconnect the power before working on the IP Board.
4-10
Power indicator LED is off.
Lamp(Backlight) on, no video ?
Yes
Check the RF source and check the
connection of RF cable.
Yes
Check the Power of Tuner ?
Pin #4 of Tuner : B3.3V_Tuner
-
Pin #1 of Tuner : B1.8V_Tuner
-
Yes
Check the CVBS data out of IC1001 ?
C807 : Tuner CVBS
Yes
Check the LVDS clk signal at output of
Main board. (TX)
TX2_CLK : ODD_TXCLK_DN/DP
-
TX4_CLK : EVEN_TXCLK_DN/DP
-
Yes
Check the LVDS cable?
Replace the T CON / LCD panel?
No
Check a set in the 'Stand-by mode'.
No
Input the RF source properly.
No
Change the Main Ass'y.
Check IC1001(X12).
No
Change the Main Ass'y.
Check IC1001(X12).
No
Change the Main Ass'y.
No
Please, Contact tech support.