Do you have a question about the CASCADE II 2022 and is the answer not in the manual?
Questions and answers
Jenna Cox
May 13, 2025
Led lights won’t work
1 comments:
Mr. Anderson
May 21, 2025
The LED lights on the Coast Spas Cascade II 2022 may not be working due to incorrect settings or a burned-out bulb/connection. The recommended action is to contact your dealer.
Dealer Name: _________________________ Contact your spa selling dealer if you have any queries related to your Cascade Spa. Coast spas authorized dealers are trained professionals who can assist you with spa parts, setup, operations, maintenance, and technical support. DISCLAIMER: At the time of print, this manual is accurate in its information. Coast Spas reserves all the rights to change/modify any spa designs and/or features without notification.
CASCADE II OWNER’S MANUAL 2022 TABLE OF CONTENTS Letter from Coast Spas Manufacturing Inc. Page Registering your spa Page Table of contents Page Basic information Page Important safety instructions and glossary of terms Page Infinity spa general layout Page Infinity spa features Page Start up guide—...
CASCADE II OWNER’S MANUAL 2022 PLEASE READ YOUR ENTIRE OWNER’S MANUAL BEFORE SPA OPERATION Basic Information Water Care IMPORTANT: Caring for your water by ensuring proper Always maintain your water chemistry within the following chemical usage is the single most important thing you parameters.
CASCADE II OWNER’S MANUAL 2022 IMPORTANT SAFETY INSTRUCTIONS Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY pregnant or possibly pregnant women should limit Cascade Spa water temperatures to 100 °F (38 °C).
Page 7
CASCADE II OWNER’S MANUAL 2022 WARNING: Water temperature in excess of 38 °C (100 °F) GLOSSARY OF TERMS may be injurious to your health. Before entering the Cascade Spa, AIR CONTROL: Mounted generally on the lip of measure the water temperature with an accurate thermometer. the spa, it induces warm air from the equipment WARNING: Do not use a Cascade Spa immediately following...
Page 8
CASCADE II OWNER’S MANUAL 2022 PREPARATION, SET-UP AND LOCATION GATE VALVES: Red with a grey handle is located at the inlet and outlet of the pumping FOR YOUR NEW SPA: system. Used while servicing the spa equipment, the valves open or close the water flow to the You want to keep in mind how you intend to use the spa and ...
11. Water Table Shut Off Laminar Shut Off DISCLAIMER: At the time of print, this manual is accurate in its information. Coast Spas reserves all the rights to change/modify any spa designs and/or features without notification. To check on updates or for other information, please visit www.coastspas.com...
DISCLAIMER: The pictures displayed above are for reference purpose only. Some parts may be different depending upon the spa model. DISCLAIMER: At the time of print, this manual is accurate in its information. Coast Spas reserves all the rights to change/ modify any spa designs and/or features without notification.
START UP GUIDE CASCADE II PREP FOR FILLING ! PLEASE READ ALL INSTRUCTIONS BELOW BEFORE FILLING THE SPA ! PLEASE READ ALL INSTRUCTIONS BELOW BEFORE FILLING THE SPA Using a cloth and water, wipe away any If your spa has a Crystal Clear tube the Remove the filter lock ring and lid.
Please be advised that the Spa Warranty will become void The outer core is similar to a traditional filter which traps larger if Coast Spas or any of its selling or servicing agents debris, while the inner core filters the water for particles down to determines that the spa has been exposed to Hydrogen Peroxide, 3 microns in size.
Page 13
CASCADE II OWNER’S MANUAL 2022 When you shock your spa you need to remove the cover for a DO NOT leave your Cascade Spa drained and in direct minimum of 30 minutes to ensure that the chemical gas off sunlight for extended periods of time.
CASCADE II OWNER’S MANUAL 2022 Connect only to a circuit protected by a Class A Ground Fault Circuit Interrupter (GFCI) or Residual Current Device (RCD) mounted at least 5’ (1.52M) from the inside walls of the spa/ Cascade Spa and in line of sight from the equipment compartment.
CASCADE II OWNER’S MANUAL 2022 Refer to Wiring Diagram inside the cover of the control enclosure. Refer to Installation and Safety Instructions provided by the spa manufacturer. WARNING! GFCI PROTECTION. Owner should test and reset the GFCI or RCD on a regular basis to verify its function.
Page 16
CASCADE II OWNER’S MANUAL 2022 WATER QUALITY MAINTENANCE Controlling alkalinity can help keep your pH in the appropriate range thereby lessening the need for pH balancing. If the TA Maintaining the quality of the water within the specified limits will is too low the pH level will fluctuate rapidly from high to low.
Page 17
CASCADE II OWNER’S MANUAL 2022 Assemble the diverter body by inserting the body back by rotating the jet body clock-wise (Picture 3a and 3b). Attach the diverter cap. JET MAINTENANCE CAUTION: Turn off the spa from main GFCI breaker to carry out any maintenance procedures.
CASCADE II OWNER’S MANUAL 2022 WATER CLARITY TROUBLESHOOTING PROBLEM PROBABLE CAUSE POTENTIAL SOLUTIONS Improper sanitization Add sanitizer Water Odor Excessive organics in water Shock spa with sanitizer pH is too low Adjust pH Chloramines are too high Shock spa with sanitizer ...
CASCADE II OWNER’S MANUAL 2022 TROUBLESHOOTING GUIDE SPA SYSTEM SYMPTOM PROBABLE CAUSE RECOMMENDED ACTION Spa does not work Power is turned off Reset GFCI Power is turned off Reset GFCI No display on the control panel Defective topside control Contact your Dealer ...
Page 20
CASCADE II OWNER’S MANUAL 2022 HEAT PROBLEMS PROBABLE CAUSE RECOMMENDED ACTION Error message on control panel Refer to the Reference Card for your control panel to verify the error Spa is in a different Heat Mode Set spa to “Standard Mode” ...
CASCADE II OWNER’S MANUAL 2022 DRAINING AND WINTERIZING Leave drain valve in the open position and safety cap off . To completely drain the plumbing lines, a wet/dry shop DRAINING YOUR SPA vacuum can be used to draw out any remaining water. Place After a period of 3-4 months, detergent residues from bathing the vacuum hose over the jet fittings in the spa as well as the suits and soap film will build up in your spa water.
(BLUE) GREEN, MAGENTA) DISCLAIMER: At the time of print, this manual is accurate in its information. Coast Spas reserves all the rights to change/modify any spa designs and/or features without notification. To check on updates or for other information, please visit...
Page 23
(BLUE) GREEN, MAGENTA) DISCLAIMER: At the time of print, this manual is accurate in its information. Coast Spas reserves all the rights to change/modify any spa designs and/or features without notification. To check on updates or for other information, please visit...
(119.5 at back) (47 at back) DISCLAIMER: At the time of print, this manual is accurate in its information. Coast Spas reserves all the rights to change/modify any spa designs and/or features without notification. To check on updates or for other infor- mation, please visit www.coastspas.com...
CASCADE II OWNER’S MANUAL 2022 CASCADE II SPA CONTROL PANEL The Main Screen Clean-up Cycle Wi-Fi Signal Indicator Ozone Running Lock Filter Cycle 1 Running Time Invert Screen Mode High Temperature Range Lights Jets Temperature Scale (F/C) Settings Heat Set Temperature H = H i g h Te m p e r a t u r e R a n g e SPA STATUS L = L o w Te m p e r a t u r e R a n g e...
Page 26
CASCADE II OWNER’S MANUAL 2022 Lock Icon: When displayed, indicates the panel is in a locked mode. To un-lock or lock a setting or panel lock, first press the = A d j u s t s e t t e m p e r a t u r e h i g h e r corresponding icon on the Lock Screen, then press and hold the word “Lock”...
Page 27
CASCADE II OWNER’S MANUAL 2022 The Set Temperature Press Up or Down once to display the Set Temperature (indicated by a flashing ºF or ºC, plus a 100 ºF change in color of the temperature). Pess Up or Down again to modify the Set Temperature. The Set Temperature changes immediately.
Page 28
CASCADE II OWNER’S MANUAL 2022 If there is a right arrow at the bottom of the screen, it takes you to the next page. Page Left | Page Right Dual Temperature Ranges High vs. Low Page up | Down This system incorporates two temperature range settings with independent set temperatures.
Page 29
CASCADE II OWNER’S MANUAL 2022 Circulation Mode repeat the process. Note: Turning the power off and back on again will initiate a If the spa is configured for 24HR circulation, the heater new pump priming session. Sometimes momentarily turning the pump generally runs continuously.
Page 30
CASCADE II OWNER’S MANUAL 2022 Non-Circ Systems In colder climates, an optional freeze sensor may be added to protect against freeze conditions that may not be sensed by The low-speed of pump 1 runs when the blower or any the standard sensors. Auxiliary freeze sensor protec-tion other pump is on.
Page 31
CASCADE II OWNER’S MANUAL 2022 Adjusting Filtration (Some systems will run a certain number of purge cycles per day, independent of the number of filter cycles per day. In this case, the Main Filtration purge cycles may not coincide with the start of the filter cycle). Using the same adjustment as Setting the Time, Filter Cycles If the Filter Cycle 1 duration is set for 24 hours, enabling Filter are set using a start time and a duration.
Page 32
CASCADE II OWNER’S MANUAL 2022 Drain Mode Some spas have a special feature that allows Pump 1 to be employed when draining the water. When available, this feature is a component of Hold Mode. *M0XX is a Message Code. Codes like this will be seen in the Fault Log Panel Locked and Settings Unlocked Locking/Unlocking The same steps are used to Lock and Unlock.
Page 33
CASCADE II OWNER’S MANUAL 2022 GFCI Test (Feature not available on CE rated systems.) Your systems may have GFCI configured in one of three ways: 1. GFCI test is not enabled. 2. Manual GFCI test is enabled but automatic GFCI test is Reminders not enabled.
Page 34
CASCADE II OWNER’S MANUAL 2022 Utilities GFCI Test Feature The Ground Fault Circuit Interrupter (GFCI) or Residual Current Detector(RCD) is an important safety device and is required equipment on a hot tub installation. (The GFCI Test Feature is not available on CE rated systems). Used for verifying a proper installation CE Product Your spa may be equipped with a GFCI Protection feature.
Page 35
CASCADE II OWNER’S MANUAL 2022 Flow-related checks Check for low water level, suction flow restrictions, closed valves, trapped air, too many closed jets and pump prime. On some systems, even when spa is shut down by an error condition, some equipment may occasionally turn on to continue monitoring temperature or if freeze protection is needed.
Page 36
CASCADE II OWNER’S MANUAL 2022 Miscellaneous Messages Change the water May appear on a regular schedule, i.e. every 90 days. Change the Communications error water in the spa on regular basis to maintain proper chemical The control panel is not receiving communication from the balance and sanitary conditions.
Settings ► Advanced ► Wi-Fi Settings Step 4: Once connected to the Wi-Fi Module directly open the Coast Spas app. The Coast Spas app will allow you to control and interact with the spa while you are still with in range.
CASCADE II OWNER’S MANUAL 2022 CONTROLMYSPA (LUXURY MODELS ONLY) The ControlMySpa™ system consists of: CMS™ SYSTEM CONSISTS OF: • ControlMySpa™ GATEWAY ULTRA installed on a spa/Hot Tub • iOS (Apple) ControlMySpa™ mobile app or Android ControlMySpa™ WEBSITE mobile app • ControlMySpa™ website with log-in and access to spas ControlMySpa™...
Page 39
CASCADE II OWNER’S MANUAL 2022 GATEWAY ULTRA Home ControlMySpa™ Module Router Connect GATEWAY ULTRA hardware in your home Step 1 Plug the supplied ethernet cable into the home router (A). Step 2 Plug the other end of the ethernet cable into the GATEWAY ULTRA module (B).
Page 40
CASCADE II OWNER’S MANUAL 2022 CMS ™ Code Overview WHAT IS A CMS™ CODE? • CMS™ Code is an 8 digit letter/number combination EXAMPLE CMS™ Code: ABC-12345 that all Spa owners must have to use spas equipped ABC = 3 letter code unique to each spa Manufacturer or OEM with the ControlMySpa™...
Page 41
CASCADE II OWNER’S MANUAL 2022 5. Press "Yes" 6. Press "Next" The serial number in the app should The CMS code is provided by match the serial number on the back your Dealer. Press "Next". Module of the spa module. 7.
CASCADE II OWNER’S MANUAL 2022 BALBOA BLUETOOTH AUDIO Pairing Smart Device • Power up the system pack with bba2 already connected to the system pack. • On the control panel press the music button. Next, press the power button. • Turn on Bluetooth function of your smart device or music device.
Page 43
CASCADE II OWNER’S MANUAL 2022 SELECT INPUT MODE The following input modes are available: Bluetooth, Line In. All control systems are equipped with Bluetooth mode. However, control systems may or may not have Line In, as this input mode is optional. Follow these steps to select the input mode of the bba 3 amplifier.
Page 44
CASCADE II OWNER’S MANUAL 2022 TROUBLESHOOTING Scenario 01 Problem: The error message “BT Comm Lost” (A) appears on the panel display. Solution: The control system has lost communication with the 3 amplifier (B). Contact customer support for help. Scenario 02 Problem: When you try to connect your music device to Aux In on the bba amplifier, the Aux In connectors on your bba...
CASCADE II OWNER’S MANUAL 2022 COAST STATUS Compatible with BP Spa Packs: North American (NA) Packs: 56689-03 and 56683-05 European (EU) Packs: 56688-04 and 56690-03 Coast Status is designed to give real time status of the spa. LED’s will be tied to a cabinet mounted light fitting that the spa owner can use to tell, at a glance, if all is OK with the spa or if something requires their attention.
Page 46
CASCADE II OWNER’S MANUAL 2022 To check message on the Control Panel screen, tap on icon. COAST STATUS MESSAGES Message Message Message Message Message Message Text Text Text <none> The clock has failed The GFCI test failed Possible freezing condition The settings have been reset Hold (aka Standby) Mode Test the GFCI...
EASY MAINTENANCE chlorine or bromine in the water as required in your specific • Your NEW Coast Spas EcoClean UV Sterilizer is installed out region (Canada 3 to 5 ppm of chlorine or bromine). of sight, concealed by your spa skirt. Quick access is gained •...
Need help?
Do you have a question about the CASCADE II 2022 and is the answer not in the manual?
Questions and answers
Led lights won’t work
The LED lights on the Coast Spas Cascade II 2022 may not be working due to incorrect settings or a burned-out bulb/connection. The recommended action is to contact your dealer.
This answer is automatically generated