Product Installation; Note; Installation Method - Genie GEB User Manual

3.0 Product Installation

3.1 Note

1. Make sure the unit is powered off before installation.
2. Check that the power supply voltage is consistent with the electric voltage to
3. Do not use in an environment beyond the boundaries of the temperature, and
4. The installation and maintenance of this product should be professional, please
5. Before installation, please prepare the following tools:
•
•
•
•
•
•

3.2 Installation Method

1. Check the equipment and make sure you have everything you need.
2. Mount the bracket or base. If it's a cement wall you will need to install using the
3. When mounting the camera, adjust the lens position and make sure it's aimed
Note: The wall needs to bear at least 3x the weight of bracket (base) and camera.
7
prevent damage to the device.
maintain good ventilation to prevent the risk of fire or electric shock.
do not in any way remove or modify the equipment and only use the required
accessories from the manufacturers. Problems caused by unauthorised repair
are at your own risk
A straight or a Phillips-head screwdriver
Multi-meter
Scissors
Needle nose pliers
Tape measure
Pencil
expansion screws that need a stand or base hole, and then mount the bracket
or base. If it's a wooden wall, use self-tapping screws to mount.
at the monitoring points with a clear picture. Manually fix the lens location and
adjust the hemisphere cover. Re-examine the screen to see whether the camera
meets the requirement. Tighten the hemisphere cover.