Water Heating; Initial Heating - Faber AFENTA Quick Start Manual

POWER ON
Switching on appliance: Press the T1 or T3 button or T1 and T3
simultaneously to turn on the device.
Press T1 and T3 simultaneously for 2 seconds to turn off the device.

WATER HEATING

The first time it is switched on, it is necessary to wait for the water to be
heated before being able to proceed with coffee brewing.
All the dispensing functions are disabled and the heating phase is
signaled to the user with slow flashing of the ICO1 and ICO 3 LEDs (1
second).
As soon as the correct water temperature is reached, all functions are
enabled and the machine is ready for delivery.
The machine ready phase is signaled to the user with fixed lighting of the
ICO1 and ICO 3 LEDs

INITIAL HEATING

When the machine is turned on, when the working temperature is
reached, the pump is automatically turned on for 0.8 seconds to preheat
the water present between the exchanger and the infuser. The function
is not carried out if the exchanger heats up in less than 5 seconds (it
was already hot)
Activate by default
COFFEE FUNCTION
(2 timed doses programmable by the user)
Short or long coffee button (T1 - T3): momentary pressure to start-stop
dispensing.
Stop automatic brewing when the preset time is reached or by pressing
the coffee button during brewing.
The brewing in progress is signaled by the flashing of only the LED (ICO1
or ICO3) corresponding to brewing in progress.
The user can plan the duration or volume of short or long coffee
brewing as desired with the following operating mode (like for example
reprogramming short coffee):
1. Start brewing by pressing and holding the T1 button.
2. End the brewing by releasing the button when the desired quantity is
reached.
3. The new brewing duration is automatically saved and will be repeated
for every subsequent brewing.
13