Table of Contents
Advertisement
<Assembly precaution>
When mounting, align form of the motor support rub-
ber (rear) unit with form of the body cover connection
3. Remove the lead wires by shifting the noise suppressor
unit.
* Take care not to damage the noise suppressor when
shifting the noise suppressor unit.
* There is a tape (glass tape) wrapped on the faston
terminals, and when removing the faston terminals,
press on to the protrusion on the faston terminal
(arrow) as shown in fig. 5.
It can be removed by pressing on the tape from
above.
* When mounting the motor, make sure to wrap the
faston terminals of the connected lead wires with the
protection tape B (glass tape).
4. Remove the noise suppressor unit, the motor support
rubber (front), and the motor support rubber (rear) unit.
7
Advertisement
Table of Contents
