Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for JB Systems HF-TWIN
-
Page 3: Before Use
ENGLISH OPERATION MANUAL OPERATION MANUAL ® Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. FEATURES This unit is radio-interference suppressed. This appliance meets the requirements of the current European and national guidelines. -
Page 4: Safety Instructions
• In the event of serious operating problems, stop using the appliance and contact your dealer immediately. • Please use the original packing when the device is to be transported. • Due to safety reasons it is prohibited to make unauthorized modifications to the unit. JB SYSTEMS HF-TWIN RECEIVER ®... -
Page 5: Receiver Functions
13. Balanced output A: Balanced male XLR audio output connector from receiver A. Connect it with a bal- anced audio cable to your mixer or pre-amplifier. 14. AUX: 6.3mm jack connector. On this connector there is a mixed signal from both receivers (A and B). JB SYSTEMS HF-TWIN RECEIVER ®... - Page 6 2. DISPLAY: shows the channel (1-16), the frequency and the battery status of the microphone. 3. IR SENSOR: receives the IR-signal from the HF-TWIN RE- CEIVER during setup of the chosen channel to work on. 4. ON/OFF SWITCH: to turn the HF-MIC on and off.
-
Page 7: Setup And Connections
SETUP AND CONNECTIONS ! Some important notes before we start ! • The HF-TWIN RECEIVER can be used with two transmitters (handheld mic / belt pack) at the same time. • Receiver and transmitter(s) should always use the same channel settings (frequency)! •... - Page 8 • Hold the IR-sensor (3) of the HF-MIC in front of the IR-indicator (2) of the HF-TWIN RECEIVER. • Press the IR-KNOB A (6) or the IR-KNOB B (8) on the HF-TWIN RECEIVER for about 2 seconds. The IR- indicator symbol (H) will start blinking 3 times. When the blinking stops, the HF-MIC has received the channel information from the HF-TWIN RECEIVER and will now work with this part (A or B) from the re- ceiver.
-
Page 9: Troubleshooting
• Hold the IR-sensor (7) of the HF-BPACK in front of the IR-indicator (2) of the HF-TWIN RECEIVER. • Press the IR-KNOB A (6) or the IR-KNOB B (8) on the HF-TWIN RECEIVER for about 2 seconds. The IR- indicator symbol (H) will start blinking 3 times. When the blinking stops, the HF-MIC has received the channel information from the HF-TWIN RECEIVER and will now work with this part (A or B) from the re- ceiver. -
Page 10: Specifications
This unit is radio-interference suppressed. This appliance meets the requirements of the current European and national guidelines. Conformity has been established and the relevant statements and documents have been deposited by the manufacturer. HF-TWIN RECEIVER Carrier Frequency Range: 823-832MHz Modulation Mode:...