Power Supply - Linear M&S VMC1 Instructions Manual

Power Supply

Power Unit Internal Wiring
In the unlikely case that the TE6D electrical connectors becomes unplugged, the power supply unit connects to the Master Station as shown
in Figure 6. Ensure that the wires are connected. There is a six pin connector and a two-pin connector.
The six-pin connector is the low voltage (13.8 V, 3.8 amp) output from the TE6D Power Supply Unit:
• Position 4 is the Black zero volt Negative onnection to the Master
• Position 2 is the Red 13.8V Positive to the Master
The two-pin connector is for the 110/120 High Voltage input:
• Black wire is position 1
• White wire in position 2
NOTE: Be sure all power cables entering the transformer enclosure are secured with cable strain reliefs
Large
Hole
Black
White Wires
Groundwire
Left Side
120V Connection
ALL AC ELECTRICAL CONNECTIONS TO THE POWER SOURCE TE6D POWER SUPPLY MUST BE MADE BY A LICENSED ELECTRICIAN AND
MUST OBSERVE ALL NATIONAL AND LOCAL ELECTRICAL CODES
16
Figure 6
TE6D Power Supply
TOP
Sleeve
12V
Bottom
Two Pin Connector
WARNING
Small wire
Hole
VMC Power Supply
6 Pin Connector
6
5
4 BLACK
3
Wires
2 RED
1
Six Pin Connector