Advertisement
TEST FUNCTION
Enter programming mode and go to menu
RESET/ENTER and on the display will be shown 4 dashes witch correspond to the positioner inputs: the dash
in the lower (upper) position means an open (closed) input.
The Input test consists of closing the input switches and verify the correspondence between what is visualised
on the display and the following picture:
To enter output test press RESET/ENTER on the display 4 dashes are displayed, its last right one flashes. .
Each dash represents an output:.From right to left the dashes are represented as follows: START/STOP,
SLOW/FAST, FORWARD/BACKWARD, POSITIONING END (see next picture).
The flashing dash indicates the selected output.
The dash position indicates the output condition: an upper (lower) position means an active(inactive,idle)
output.
Press
Press
You can change alternatively from input test to output test by pressing RESET/ENTER .
To exit the test mode press PGM.
data: 13/01/16
, press RESET/ENTER, insert password 273, confirm by
DISPLAY
to select the required output (the flashing dash will change)
to activate the selected output; the selected dash will move to the upper position
(see following picture)
DISPLAY
File: P2XT_smd_ing.doc
INGRESSO CHIUSO
NESSUNO
START
PRESET
PIECECOUNTER
EMERGENCY
USCITA ATTIVA
NESSUNA
START/STOP
SLOW/FAST
FORWARD/BACKWARD
POSITIONING END
pag 8 di 10
Advertisement
