Advertisement
• Dimensions upper limit
As for the previous constant, the positioner prevents the entry of dimensions exceeding the value set in this
constant. Set a value upper then the maximum value of positioning dimensions
• Display mode
Setting this function gives the possibility to convert the quota visualized on the display in a quota expressed in
inch fraction or degrees. Keeping pressed the key PGM for abt. 3 seconds is possible proceed to a type of
visualization to an other.
The constant
defines the type of conversion of the quota, using keys
and
select the
visualization needed according to the following table:
DISPLAY FUNCTION
Disabled
From tenth of mm to thousandths of an inch
From tenth of mm to hundredths of an inch
From mm to hundredths of an inch
From mm to tenths of an inch
From cm to hundredths of an inch
From dm to inches
Sexagesimal degrees with display in degrees and prime numbers
Sexagesimal degrees with display in degrees
• Baud rate for serial output
Not used in this version, don't change (or set to)
.
MANUAL WORKING MODE
In manual working mode it is possible to displace the positioned axis by using the keyboard: enter
programming mode and go to menu
, press RESET/ENTER and the display will show the current
dimension; the auxiliary display will show "
" which indicates the manual working mode.
The key
causes a fast forward displacement of the positioned axis.
The key
causes a fast backward displacement of the positioned axis.
N.B. emergency input must be closed.
Press PGM to exit manual working mode .
data: 13/01/16
File: P2XT_smd_ing.doc
pag 7 di 10
Advertisement
