Technical Data; System Requirements - Philips GoGear SA2SPK User Manual

Philips mp3 player user manual
Table of Contents

Advertisement

14 Technical data

Power
Power supply: 220 mAh Li-ion polymer
internal rechargeable battery
Play time¹ (music): 22 hours
Software
Philips Songbird: to update firmware and
transfer music
Connectivity
Headphone 3.5 mm
USB 2.0 High speed
Sound
Channel separation: 45 dB
Frequency Response: 80 - 18,000 Hz
Output power: 2 x 2.4 mW
Signal to noise ratio: > 84 dB
Audio playback
Supported formats:
MP3, WAV, WMA, FLAC, APE
Bit rates
MP3:
8 - 320 kbps and
VBR
WMA:
5 - 320 kbps
FLAC:
up to 1.1 Mbps
APE:
up to 1.3 Mbps
Picture display
Supported formats:
JPG
BMP
Storage media
Built-in memory capacity²:
SA2SPK02 2GB NAND Flash
SA2SPK04 4GB NAND Flash
SA2SPK08 8GB NAND Flash
EN
26
Sampling rates
8, 11.025, 16,
22.050, 32, 44.1,
48 kHz
8, 11.025, 16,
22.050, 32, 44.1,
48 kHz
48 kHz
48 Khz
Music sync transfer³
Philips Songbird
Music / Picture drag and drop transfer³
Windows Explorer
Display
Color LCD 128 x 128 pixels
Note
¹ Rechargeable batteries have a limited number
of charge cycles. Battery life and number of
charge cycles vary by use and settings.
² 1GB = 1 billion bytes; available storage
capacity is less. Full memory capacity may
not be available as some memory is reserved
for the player. Storage capacity is based on 4
minutes per song and 128 kbps MP3 encoding.
³ Transfer speed depends on operating system
and software configuration.

System requirements

Windows® XP (SP2 or above) / Vista / 7
Pentium III 800 MHz processor or higher
520 MB RAM
500 MB hard disk space
Internet connection
Windows® Internet Explorer 6.0 or later
USB port

Advertisement

Table of Contents
loading

Table of Contents