Update Spark; Manually Verify / Update The Firmware - Philips GoGear SA2SPK User Manual

4 Update SPARK

SPARK is controlled by an internal program
called firmware. Newer versions of the
firmware may have been released after you
have purchased SPARK.
The software program called Philips Songbird
can use your computer to check for firmware
updates that are available on the Internet.
Install Philips Songbird on your computer
(see chapter Install software) and follow the
instructions to update (see chapter Manually
verify / update the firmware).
Note
•
Your music files are not affected by a firmware
update.
Manually verify / update the
firmware
1
Ensure that your computer is connected
to the Internet.
2
Connect SPARK to the computer
(see section Connect and charge for
instructions).
3
On your computer, click Start >
Programs > Philips > Philips Songbird to
launch the Philips Songbird application.
4
Select Tools > Updates
» Philips Songbird checks for updates
and installs new firmware from the
Internet, if available.
5
Follow the on-screen instructions to
update the firmware of SPARK.
6
Wait until the update is completed, then
disconnect SPARK from the computer.
» SPARK restarts after the firmware is
updated and is ready for use again.
EN
10