Sea Breeze HIGH EFFICIENCY SMZCA12H4ZIGX Installation And User Manual page 10

FOLLOW ME - Press this button, the room temperature sensor is by the remote control. Press this
button again and the room temperature sensor will be in the indoor unit. This function is not activated for
Cassette Unit.
–Press the left blank button will illuminate
ICON
with the units.
ICON – Press the right blank button will illuminate
affect with the units.
TEMP – Press this button, the icons will be cycled between
displays set temperature always.
set temperature. displays the set temperature.
ºF or º C - Turn unit off, press MODE and (-) buttons simultaneously to switch ºC or ºF.
REPLACING BATTERIES
The battery cover is fixed on the remote with a screw. Please unscrew it for
the very first time. (For easy use, the screw is unnecessarily to be installed
back after the batteries is placed.)
Slightly press down on the arrow on the battery cover and slide in the direction of
the arrowhead .
Remove old batteries. Insert two new AAA 1.5V batteries, paying attention to the
polarity. Re-install the back cover of wireless remote control.
NOTE:
D o not use the old, different, or rechargeable batteries.
If the wireless remote control will not be used for a long period of time, remove the batteries.
If the wireless remote control does not operate properly, remove the batteries for 30 seconds and re-
install (resets the remote).
CAUTION
 Turn main power off before cleaning air conditioner.
 Never spray water into the indoor or outdoor unit for cleaning.
 Volatile liquids (e.g. solvent, gasoline, etc.) will damage the air conditioner. Wipe the
unit with a dry soft cloth, or a cloth lightly moistened with water.
1. Cleaning the Air Filter (Recommended once every six months)
NOTE: If the unit is installed in an abnormally dusty area it is advised
the filters be cleaned more often.
 Open the air inlet grille.
the two handles on the air inlet grill at the same time
with the direction showed by arrow in Figure 1.
950-0206revE
displays room temperature for a few seconds then display the
ROUTINE CARE AND MAINTENANCE
Remove 2 screws. Slide
- 10 -
icon in the remote display but will have no affect
icon in the remote display but will have no
, and in the remote display.
Figure 1
February 12, 2015