Table of Contents
Advertisement
NLRinse System
Top up the rinse aid up to the max
2.
mark.
If rinse aid has spilled over, it must
3.
be removed from the rinse aid
container.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
Close the lid of the rinse aid
4.
reservoir.
aThe lid audibly clicks into place.
Set the rinse aid amount
If streaks or water spots remain on the
dishes, adjust the amount of rinse aid.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
aThe display shows H:xx
to give.
aThe display shows
to give.
Just as often on
3.
until the display shows the
factory-set value r:05.
Press or repeatedly until
4.
the desired farm
rinse aid is in
30
max
Busy-
reflected
to press
elity glossy
suggested.
– A low setting adds less rinse aid
during the wash cycle, reducing
the streaks on the dishes.
– A higher setting adds more rinse
aid during the wash cycle,
reducing water spots and
improving drying results.
To save the settings, press . for
5.
about 3 seconds
Switch off rinse system
If the rinse aid refill indicator bothers
you, e.g. if you use a combined
dishwasher detergent with a rinse aid
component, you can switch off the
rinse system.
Tip:The function of the rinse aid is
limited in combination detergents. You
usually get better results by using
rinse aid.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
aThe display shows H:xx
to give.
aThe display shows
to give.
Just as often on
3.
until the display shows the
factory-set value r:05.
Press or repeatedly until the display
4.
shows r:00.
to press.
Busy-
reflected
to press
Advertisement
Table of Contents
