For Dealers; Notes On Installation And Usage; Unsuitable Installation - Sony VPL-FE40 Manual

For dealers

Please read throughly this Safety
Regulations and Installation Manual for
Dealers contained in the CD-ROM for safe
installation.
On safety
• Avoid using an extension cord with a low
voltage limited since it may cause the
short-circuit and physical incidents.
• Do not catch your finger between the unit
and surface of the floor when moving the
projector installed on the floor.
• Be careful not to catch your finger in the
cooling fan.
• Do not carry the projector with the cabinet
on and with its cover open.
On installation
• When the projector is mounted on the
ceiling, the Sony PSS-610 Projector
Suspension Support must be used for
installation.
• Allow adequate air circulation to prevent
internal heat build-up. Do not place the
unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that
may block the ventilation holes. Leave
space of more than 30 cm (11 7/8 inches)
between the wall and the projector. Be
aware that room heat rises to the ceiling;
check that the temperature near the
installation location is not excessive.
• Install the projector on the floor or ceiling.
Any other installation causes a
mulfunction such as color irregularity or
shortening lamp life.
• Do not install the unit in a location near
heat sources such as radiators or air ducts,
or in a place subject to direct sunlight,
excessive dust or humidity, mechanical
vibration or shock.
• To avoid moisture condensation, do not
install the unit in a location where the
temperature may rise rapidly.
• Be sure to secure the cabinet cover firmly
when installing to the ceiling firmly.
Notes on Installation
and Usage

Unsuitable Installation

Do not install the unit in the following
situations. These installations may cause
malfunction or damage to the unit.
Poorly ventilated
• Allow adequate air circulation to prevent
internal heat build-up. Do not place the
unit on surfaces (rugs, blankets, etc.) or
near materials (curtains, draperies) that
may block the ventilation holes.
• When the internal heat builds up due to the
block-up, the temperature sensor will
function with the message "High temp.!
Lamp off in 1 min." The power will be
turned off automatically after one minute.
• Leave space of more than 30 cm (11
inches) around the unit.
• Be careful that the ventilation holes may
inhale tininess such as a piece of paper.
Highly heated and humid
• Avoid installing the unit in a location
where the temperature or humidity is very
high, or temperature is very low.
• To avoid moisture condensation, do not
install the unit in a location where the
temperature may rise rapidly.

Notes on Installation and Usage

7
/
8
5
GB