Advertisement
Instruction Manual
STAND ANCHORING PROCEDURES
NOTE: Due to the wide variety of anchoring options, hard-
ware is not provided.
Anchor stand follows:
1. Select a suitable location for anchoring, allowing for room
for swivel and access for cabling.
2. Using the template provided, drill anchoring holes for the
four 1/4-20 X 1/2" tapped holes (see Figure 7).
3. If routing cables through mounting surface, Use the tem-
plate provided and drill the cable access hole in the
mounting surface.
CABLE MANAGEMENT
Install cables as follows:
1. Attach cabling to flat panel display.
2. Route cables in one of three ways:
a. down the back of the display (open),
b. through the center post of the stand and out the bot-
tom of the stand in the back,
c.
through the center post of the stand and through a
hole in the mounting surface.
6
1/4-20 X 1/2" Tapped holes
Figure 7. Anchoring Hole Locations
Swivel Stand
Advertisement
