PAX -100 Quick Start Manual

Quick-Start Guide
Please read the User's Manual before using the unit
WARNING
1-888-522-0729 | P AXI NNOVATIO NS.C OM | I NF O@ PA XI NN OVAT ION S.C O M
Remove the tank from the unit by pulling the black lock that holds
the tank in place, then pull the tank down and towards the front
of the unit. You can now fill the tank with the disinfectant of your
choice and reinstall it in the PAX-100.
Refer to the Safety Data Sheet of the disinfectant of your choice
for any protective equipment recommended when handling the
product.
Ensure that any surface with visible dirt is cleaned prior to using
the sprayer to ensure even coverage of the disinfectant.
To start the unit, press and hold the button on the handle. A 20-
second delay to prime the pump is possible, this is normal
operation. Hold the handle firmly while the machine is in
operation to ensure optimum performance.
Spray the desired surfaces with an "S" shaped sweeping motion. If
the disinfectant accumulates on the surfaces, the speed of
disinfectant application should be increased.
To maximize the life of the PAX-100, it is important to rinse the
unit at the end of each day of use. Pour the surplus of disinfectant
into its container, then rinse and fill the tank with hot water.
Put the tank back in place. Spray hot water for at least 30 seconds
into a container or towards a drain. This will prevent the
accumulation of residue in the internal components of the PAX-
100, which can cause long-term issues.
Empty the tank and reinstall it on the PAX-100. The unit can now
be stored until the next disinfection.
Although the PAX-100 has an internal battery allowing more
than 8 hours of continuous operation, the unit should always be
plugged in when stored.
This device can cause electrostatic shocks.
This unit has been designed for one-handed use.