Philips 7819901519 Quick Start Manual

1 Connect Antenna or Cable service to RF-IN jack on the unit
using RF cable
2 Connect DVD Recorder to your TV set using AV cable
picture below)
Thank you for purchasing PHILIPS DVD Recorder.
3 If you have other AV sources you wish to connect to this DVD
Please follow the step-by-step instructions to
recorder, see panel A, B, C below for reference.
connect and set up your new DVD recorder.
4 Attach power cord to the DVD recorder and then connect to
the wall outlet
Please complete these recommended steps
5 Press POWER key on the remote or front panel to turn on the
before using your recorder. For more advanced
DVD recorder.
setups and operations, please refer to the
User's Manual. If you encounter any problem
6 Turn on your TV and switch to proper input.
setting up or operating this DVD recorder,
7 Proceed with Step 3
please refer to the "Troubleshooting" section
in the User's Manual before contacting technical
support.
1
Connect VCR to the DVD recorder using AV cable
below) .
2
Connect the power cords of both VCR and DVD recorder to
the wall power outlet. Turn the VCR and the DVD recorder
on.
.
(see picture below)
(see
.
(see picture on the right) .
on the back page
(see picture
1
Connect Camcorder to the DVD recorder using AV cable
(see picture below)
2
If the DVD recorder is not connected to a TV set, return
to the Connection Guide above to continue connecting
the recorder to TV.
Note: For advanced connections, please refer to the "Connecting Up" section (p.6) in the User's Manual.
1 Connect Cable Converter/Satellite Receiver to RF-IN jack on
the unit using RF cable
(see picture below).
2 Connect DVD Recorder to your TV set using AV cable
picture below).
If you need to use a setup box, cable converter or satellite receiver
to receive TV signal, skip channel setup in STEP 3 on the next page.
3 If you have other AV sources you wish to connect to this DVD
recorder, see panel A, B, C below for reference.
4 Attach power cord to the DVD recorder and then connect
to the wall outlet
(see picture on the right).
5 Press POWER key on the remote or front panel to turn on
the DVD recorder.
6 Turn on your TV and switch to proper input.
7 Proceed with Step 3 on the back page.
1
Connect DV to the DVD recorder using DV cable
.
picture below)
2
If the DVD recorder is not connected to a TV set, return to
.
the Connection Guide above to continue connecting the
recorder to TV.
(see
(see
P/N 7819901519