SENDER RAMPS FLY RAMP Manual

SENDER FLY RAMP – 16 PLUS RAMPS iN ONE
PLEASE TAKE EXTREME CARE OPENING YOUR FLY RAMP – DO NOT USE A KNIFE!
TAKE THE OPPORTUNITY TO OBSERVE HOW THE FLY COMPONENTS FOLD AND STORE!
Thank you for buying our FLY RAMP. It is the most adjustable ramp ever designed and manufactured. It has been a long term
project that has stretched our experience and knowledge of geometry and woodworking. Each part has been carefully
considered for weight and strength. Our solution provides you with EVERY RAMP you would ever need to progress and LEARN to
FLY. Welcome onboard SENDER AIRWAYS ;)
Build confidence with ease – Gain height in small increments and become familiar with straight and curved take offs!
MODULAR:
In addition, our ramp integrates with the rest of the SENDER BOLT ON Range at 350 Height! This is the perfect coaching height
where our Pump Roller, Compression Roller, Tabletop and Seesaw Booster Kit all work perfectly.
The FLY can be used as a take-off ramp which is Straight or Curved but only as a landing ramp in STRAIGHT MODE and NEVER
with the extension attached! The extension is not designed to take impact loads.
The ramp has TERRAIN ADJUSTMENT. Once set at a specific height you can micro adjust legs to stabilise. The ramp is best used
on grass but can be used on tar or concrete. However, the severity of landing and risk factor will greatly increase.
RAMP RANGE / ADJUSTMENT:

STRAIGHT – 350 – 400 – 450 – 500 – 550 – 600

CURVED – 400 – 450 – 500 – 550 – 600 – 650 – **690 - 725 – **760 – 800
** These heights have marker holes but to avoid clutter on the legs (clear markings) we have left it for you to go freeride and set
the legs between the next and previous marker numbers to create your own take off!
SAFE OPERATION!
Once you are familiar with all the parts you can set up, fold and pack THE FLY in 5 – 10 minutes or less. You can easily adjust the
ramp to the next height in a matter of minutes. However, YOU MUST ALWAYS check the components are bolted tightly together
to prevent the ramp from failing / folding or collapsing. Some parts have SKULLs to indicate the importance of tightening bolts.
EXTENSION COMPONENT MUST BE FITTED / USED