Description Of The Appliance; Before First Use; Filling With Water - Oster GCSTBS5001 Instruction Manual

DESCRIPTION OF THE APPLIANCE

1. Soleplate
2. Spray Nozzle
3. Water Door
4. Steam Dial
5. Shot of Steam Button (only on model
GCSTBS505X)
• When using the Iron for the first time, test it on a piece of old cloth to be sure that the Soleplate and the
Water reservoir are clean.
• It is possible that the Iron will discharge some smoke or give off a slight odor during it is first usage. This is
due to the initial heating of the materials used. This is completely normal and will stop shortly afterwards.
• When not ironing, always have the Steam Select Switch turned to the close position
• This Steam iron may be used by normal tap water. However, if the water if the region in which you live is
especially hard, it is recommended to use distilled water to prolong the life of your iron.
• Do not use water that has been desalinated with chemicals.
1. Turn off the Iron and disconnect the plug from the electrical wall outlet
before filling the Iron with water.
2. Turn the Steam Select Switch to the closed position
3. Set the Iron in the position indicated below (figure 2) and fill it with
water, no higher than the Max fill level shown on the See-Through Water
Window.
GCSTBS5001_GCSTBS5002_GCSTBS5003_GCSTBS5004_GCSTBS5051_GCSTBS5052_GCSTBS5053_20SEM1 (LA).indd 3

BEFORE FIRST USE

INSTRUCTIONS FOR USE
CHOOSING THE RIGHT WATER

FILLING WITH WATER

E ng l ish - 3
6. Strain Relief
7. Handle Top/Heel
8. Water tank
9. Spray trigger
10. Temperature Control Dial
.
.
figure 2
11/19/20 4:05 PM