Table of Contents
Advertisement
Quick Links
CGS TGC Installation, Operation & Maintenance
Timed Gas Controller
Model: CGS TGC
Installation, Operation & Maintenance Manual
Please read this manual carefully and retain for future use.
For specific requirements that may deviate from the information in this guide – contact your supplier.
Canadian Gas Safety LLC
www.canadiangassafety.com
CGS TGC v2 220322
1
Advertisement
Table of Contents
Related Manuals for CGS CGS TGC
Summary of Contents for CGS CGS TGC
- Page 1 CGS TGC Installation, Operation & Maintenance Timed Gas Controller Model: CGS TGC Installation, Operation & Maintenance Manual Please read this manual carefully and retain for future use. For specific requirements that may deviate from the information in this guide – contact your supplier.
-
Page 2: Table Of Contents
CGS TGC Installation, Operation & Maintenance Contents Important Warning Statements ..............3 Installation ....................4 Typical Application & Location .................... 4 Mounting & Cabling ....................... 4 Circuit Board Terminals ......................5 Wiring – Power Inputs ......................5 Wiring – Gas Valve Outputs ....................6 Wiring –... -
Page 3: Important Warning Statements
Any parts that form part of the connections/installation must have a minimum fire-retardant rating of UL 94V-2! Use with a low-profile surface mount or flush cover available from CGS! Your product should reach you in perfect condition, if you suspect it is damaged, contact your supplier Manufacturer’s Warranty Statement... -
Page 4: Installation
Isolate the equipment from all hazardous live power sources before opening the cover! The CGS – Timed Gas Controller (TGC) is carefully designed for the commercial and hospitality sector to control the gas supply for a range of appliances such as fireplaces, fire pits and barbeques etc. -
Page 5: Circuit Board Terminals
Alternatively, the unit can be powered via the 24V [POWER IN] terminal. This can be AC or DC. When power is connected/live, a red LED will illuminate on the front of the controller on the CGS Logo. CGS TGC v2 220322... -
Page 6: Wiring - Gas Valve Outputs
CGS TGC Installation, Operation & Maintenance Wiring – Gas Valve Outputs A gas solenoid valve should be powered using one of the terminals marked [VALVE OUT]. Terminals offer control via mains 100-120V~ or 24V~ When wired to a normally closed gas solenoid valve, the TGC controller can be used to isolate the gas supply either by;... -
Page 7: Basic Operation
CGS TGC Installation, Operation & Maintenance Basic Operation Isolate the equipment from all hazardous live power sources before opening the cover! When power is supplied to the TGC controller, the LED on the log of the cover will illuminate Red. To turn the TGC controller off, disconnect electrical power supply. -
Page 8: Specification
FCC CFR 47 Parts 15, 107 & 109 Every effort is made to ensure the accuracy of this document; however, CGS can assume no responsibility for any errors or omissions in this document or their consequences. CGS would greatly appreciate being informed of any errors or omissions that may be found in the content of this document.