Download Print this page

ArduCAM Raspberry Pi Getting Started

Advertisement

Quick Links

64MP-AF Synchronized
Quad-Camera Kit
for Raspberry Pi
Getting Started
Published in May 2022
by ARDUCAM TECHNOLOGY CO., LIMITED

Advertisement

loading

Summary of Contents for ArduCAM Raspberry Pi

  • Page 1 64MP-AF Synchronized Quad-Camera Kit for Raspberry Pi Getting Started Published in May 2022 by ARDUCAM TECHNOLOGY CO., LIMITED...
  • Page 2: Installation

    1 x Quad-Camera HAT (Exclusive Version) Arducam UC-693 4 x Fex Cable (For Cameras) Turn o your Raspberry Pi and disconnect the power supply. 1. Connect the HAT’s MIPI_TX0 port to Raspberry Pi’s camera port. 64MP-AF Synchronized Quad-Camera Kit for Raspberry Pi...
  • Page 3 Installation 2. Connect the Quad-Camera HAT. 3. Connect the 4 camera modules to the Rx ports. 4. Power your Raspberry Pi on. 64MP-AF Synchronized Quad-Camera Kit for Raspberry Pi...
  • Page 4: Operating The Camera

    Connecting any of the 64MP camera modules directly to Raspberry Pi will not work, the cameras in the kit must be used with the quad-camera HAT. Make sure you are running a newer version of Raspberry Pi OS, a fresh install is highly recommended. (01/28/22 or later releases) For Pi 0 ~ 3 users, pls also: 1.
  • Page 5 -t 5000 --viewfinder-width 2312 --viewfinder-height 1736 --width 4624--height 3472 -o 64mp.jpg --autofocus If you are using 64MP camera with older Pi models, pls set the resolution to 16MP (superpixel mode): --width 4624 --height 3472 64MP-AF Synchronized Quad-Camera Kit for Raspberry Pi...
  • Page 6 By default, it’s set to 50, and you can change it to any value between 1 ~ 1023. By default, the quad-camera kit works in synchronized 4-channel mode (more modes will be added in future updates), and Raspberry Pi recognizes the whole kit as one camera. Any manual focus or camera control adjustments (exposure/gain/white balance/etc.) will also be applied to 4 cameras at the same time.
  • Page 7: Instructions For Safe Use

    Instructions for Safe Use To properly use the Arducam quad-camera kit, kindly note: Before connecting, you should always power the Raspberry Pi off and remove the power supply first. Make sure the cable on the camera board is locked in place.
  • Page 8 MIPI DSI and MIPI CSI are service marks of MIPI Alliance, Inc Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi Foundation Arducam High-Resolution Autofocus Camera And Arducam logo are trademarks of ARDUCAM TECHNOLOGY CO., LIMITED...

This manual is also suitable for:

B0402