Programming For Automatic Watering - Parkside 393778 2104 Operation And Safety Notes

The minute display in the "Time" section will flash on
screen.
3. Set the time in minutes with the rotary control
30 minutes) and confirm with the
The cursor in the "day of the week" section will flash
on screen.
4. Set the day of the week with the rotary control
confirm with the
Remark: In case you input a wrong data, you can always
press the (ON/OFF) button

Programming for automatic watering

1. Switch on the product. Press the SET button
2 seconds.
The program number display flash on the "Prog"
section will flash on screen (see Fig. 5).
2. Use the rotary button to set the program number (e. g.
Prog 3) and confirm by pressing the SET button
The hour display on the "Start" section will flash on
screen (see Fig. 6).
3. Set the hours for starting the watering time with the rotary
control
5
24 GB/IE/NI
button
(e. g. 6 hours) and confirm with the SET button
button
(see Fig. 4).
3
to go to previous step.
7
(For example
5
(see Fig. 3).
3
and
5
for approx.
4
.
4
4
.