Advertisement
Eye injury hazard! Always
wear safety glasses when
using this machine.
This machine and its
components
heavy. Get lifting help or
use power lifting equip-
ment such as a forklift to
move heavy items.
Bending material greater than capacity of
machine may damage the roller dies. Always
measure workpiece diameters before begin-
ning any bending operation.
Needed for Setup
Recommended Items
Additional Person for Lifting ............................... 1
Safety Glasses (for each person) .................. 1 Pr.
Power Drill .......................................................... 1
Drill Bit
⁄
" ......................................................... 1
5
16
Mounting Hardware ............................ As Needed
Wrench or Socket
⁄
" ................................... 2 Ea.
1
2
Clean Shop Rags ............................... As Needed
-2-
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in oil or rust preventative.
To assemble handle crank:
are
very
1.
Qty
Figure 3. Location of bending roller shaft square
2.
Figure 4. Cap screw and flat washer installed on
Install handle crank on square end of bending
roller shaft (see Figure 3).
end.
Install (1) M8-1.25 x 20 cap screw and (1)
8mm flat washer on handle crank and tighten
to secure (see Figure 4).
x 1
handle crank.
Model T32961 (Mfd. Since 9/21)
Advertisement
