Installation; Mount The Amplifier In Car - Philips CMQ205 User Manual

i FUSE: 30AX1
j POWER
• To connect +12V-DC power wire,
ground wire, and remote control
wire.
6 EN

3 Installation

Note
•
Follow all mounting and wiring instructions.

Mount the amplifier in car

You can mount the amplifier either under a seat
or on the rear tray.
Note
•
To avoid interference, do not place the
amplifier too close to the car audio or antenna.
•
The supplied mounting screws are 25mm long.
Make sure that the mounting board is thicker
than 25mm.
1
Place the unit on the location for
installation.
2
Mark the positions of the four screw
holes.
3
Drill the holes with driller of
approximately 4mm in diameter.
4
Mount the unit with the supplied screws.