Maintenance - stayer OLMO G-1 250 C Operating Instructions Manual

Maintenance

Safety and maintenance schedule
General Chain saw
Saw chain
Saw chain brake
Guide bar
Befare each start Saw chain
Guide bar
Saw chain lubrication
Saw chain brake
OFF switch, safety locking
button, accelerator lever
Lid of the fuel/oil tank
Daily Air filler
Guide bar
Guide bar support
ldling speed
Weekly Fan housing
Cylinder housing
Spark plug
Muffler
Jacket of the saw chain ratchet Check if it is damaged; replace it if necessary.
Quarterly Suction head
Fuel and oil tanks
Storage Chain saw
Guide bar/saw chain
Fuel and oil tanks
Carburetor
Clean the outside, look if there are damages. Should there
be damages, ask a qualified Service Center to repair them
immediately.
Sharpen it regularly; replace it at good time.
Ask a qualified Service Center to inspect it regularly.
Turn it around to make sure a uniform wear of the bearings.
Replace it in good time.
Check to see if it is damaged and sharpened. Check the
tension of the chain.
Check to see if it is damaged.
Check its operation.
Check its operation.
Check its tightness.
Compruebe el apriete.
Clean.
Check to see of it is damaged; clean the oil admission port..
Clean, particularly the oil guiding slot .
Check (the saw chain must not be running).
Clean to make sure appropriate air cooling.
Clean.
Check and replace if necessary.
Check tightening of the assembly.
Replace.
Clean.
Clean the outside, look if there are damages. Should there
be damages, ask a qualified Service Center to repair them
immediately.
Disassemble, clean and grease it slightly. Clean the slot of the
guide of the guide bar.
Drain and clean.
Keep running until it is drained.
/ /
29
es
it
gb
fr
p
el