Kawai CN301 Owner's Manual page 88

Appendix
3. Mounting A onto the stand
① Lift A and carefully place it onto the stand. Position A so that
the metal fitting holes are visible on the rear side of A when
viewed from above.
② Secure C in place. To prevent A from tilting and falling off,
hold the front side of A with one hand and slide A backwards.
The hook of A engages the metal fitting of the side panel.
Be careful not to have hands or fingers caught between
A and the stand.
A
88
①
②
C
A
B
4. Fastening A to the stand
① Temporarily fasten A and the stand with four screws a (with
flat washer and spring washer).
② First, loosely fasten the screws a , and move A to the position
that allows the four screws go straight in. Then, even out the
left and right overhang.
③ Lastly, tighten the temporary fastened screws a until the
spring washer becomes flat to ensure that A is rigidly at-
tached to the stand.
Make sure to fasten A to the stand using the screws.
Failure to do so could cause A to fall off from the stand,
which is extremely dangerous.
②
A
B
Front view
A
B
a
C
C