Table of Contents
Advertisement
Overview
The Time-Lapse Package is a complete system for documenting construction projects, animal behavior monitoring, analyzing
environmental changes, or other long-term outdoor photographic tasks.
Quick Start
1.
Reconnect the two-pin Red and Black power cable to the Battery converter (intentionally disconnected for shipping). This
will apply power to the camera and the controller. You might check other cable connections as well!
2.
Once the power is connected, the DigiSnap should immediately blink yellow/orange, and then a few seconds later will
blink green four times to indicate that it's ready to go. If you don't see any blinking on the LED, then check the cables
again...
3.
Turn the camera on, using the rotating power switch on the top of the camera.
4.
Press the * button on the DigiSnap, and the camera should take a picture!
5.
Let's try a Simple Time-Lapse (STL) test. Press and hold the time-lapse button on the DigiSnap. After two seconds it will
start to blink yellow/orange. Count 5 blinks (5 seconds), and then release. This has told the DigiSnap to set the time-lapse
interval to 5 seconds, and take an infinite number of pictures. Press the time-lapse button again, briefly. After a few
seconds, the camera should take a picture, and then again every 5 seconds, until the batteries give out or memory card fills.
If you press it again briefly, it should stop taking pictures.
Items included:
Fiberglass Housing, glass window.
High capacity internal battery pack.
5 Watt Solar Panel.
Harbortronics Solar Charger.
Harbortronics Battery Converter.
Here are all of the parts, before we assemble them!
Harbortronics LLC
Time-Lapse Package
Revision D
Harbortronics DigiSnap 2100.
Pentax K110D Digital SLR.
A pair of 2 GB memory cards.
All required tools, cables, manuals and accessories.
3
1/5/2007
Advertisement
Table of Contents
