Getting Started - VTech SWITCH & GO Scorpion Dune Buggy Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw,
and then open the battery cover.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 1 new AAA (LR03/AM-4) battery following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
Note: If there is no response when the scorpion is switched on,
please install brand new batteries and try switching the scorpion
on again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4